Hoptro
GUIDE · UPKEEP · 6 MIN READ

Tyres: when do they really need changing?

The law sets a limit: 1.6 mm of tread. But on a wet road, a tyre already brakes noticeably worse before it gets there. Here is how to tell where yours are, in two minutes, and when to change them.

WEAR BARNEW ≈ 8 mmTODAY 4 mm3 mm · ADVISED1.6 mm · LEGAL MINIMUM4.0MMUNDER 1.6 mm€135 fineand the car may be held

The gist in 30 seconds

4 THINGS TO REMEMBER
  1. 01French law requires at least 1.6 mm of tread. Below that: a €135 fine, and the car may be held.
  2. 02Change them around 3 mm, or 4 mm for winter tyres: near the end, they brake much worse on wet roads.
  3. 03A bulge, a cut, a deep crack: replace it straight away, even with tread left.
  4. 04Beyond 10 years, replace them even if they look fine. The date is in the DOT code.
01 · WEAR

1.6 mm is the law. 3 mm is better.

Tread depth tells you how much water the tyre can clear. The less is left, the higher the risk of aquaplaning, and the more metres the car needs to stop on a wet road.

≈ 8 mmA new car tyre, depending on the model
3 mmThe advised time to change summer tyres
4 mmThe advised limit for winter or all-season tyres
1.6 mmThe legal minimum, at the bottom of the main grooves

To spot it, look for the wear bars: small blocks moulded into the bottom of the main grooves, 1.6 mm high. A small triangle or the letters TWI on the sidewall show where they are. When the tread is level with them, the tyre has reached the legal limit.

To know where you stand before that, a tread depth gauge, a few euros from a car parts shop, gives the figure in one go. Measure in several grooves and at several points around the tyre: wear is not always even.

02 · OTHER SIGNS

Enough tread is not always enough.

A tyre can have tread left and still need replacing. Walk round the car once a month, when you check the pressures.

  1. 01

    A bulge on the sidewall

    A bump means a damaged carcass, often after hitting a kerb or a pothole. The tyre may burst: change it straight away.

  2. 02

    A cut or a deep crack

    A gash showing the fabric, or marked cracks on the sidewall: the rubber is weakened.

  3. 03

    Uneven wear

    Worn in the middle: often over-inflated. On both edges: under-inflated. On one side only: often the alignment. Have it checked, or new tyres will wear the same way.

  4. 04

    Vibrations, a car that pulls

    A shaking steering wheel or a car pulling to one side may come from a deformed tyre, the balancing or the alignment: have it checked.

  5. 05

    A puncture

    A hole in the tread can often be repaired from the inside by a professional. On the sidewall, or after driving flat, the tyre must be replaced.

TOOL 04 · FREERead a tyreSize, load and speed ratings, date of manufacture: everything written on the sidewall, decoded.Try it
03 · AGE

Even little used, a tyre ages.

Rubber hardens with time, sunlight and temperature swings: an old tyre grips less, even with tread left. No law sets a maximum age, but tyre makers give guidelines.

5 yearsFrom this age, have them inspected by a professional every year
10 yearsBeyond that, replace them even if they look fine, spare included

The date of manufacture is in the DOT code on the sidewall: its last four digits give the week, then the year. 2321 means week 23 of 2021. Our Read a tyre tool decodes it for you.

04 · FITTING THEM RIGHT

In pairs, and in the right place.

On the same axle, both tyres must be identical. And if you only change two, where the new ones go matters.

  1. 01

    Two identical tyres per axle

    Same size and same type (summer, winter or all-season): this is compulsory on an axle. Same brand and model: strongly advised.

  2. 02

    New ones at the rear

    If you only change two, tyre makers advise fitting the new ones at the rear: on a wet road, worn rear tyres let go first, and a spin is hard to catch.

  3. 03

    A size meant for the car

    It is on the label in the door frame or the fuel flap, and in the handbook. Load and speed ratings must not be lower than the original ones.

  4. 04

    Balancing, then pressure

    Wheels are balanced at each fitting. Check the pressure cold a few days later, then every month.

IN THE HOPTRO APP

The day you change them, note it.

Date, mileage, cost, garage: Hoptro keeps your tyres in the history with the rest of the upkeep, and reminds you when to have them checked, on a date or at a mileage.

Download on theApp StoreGet it onGoogle Play
Front tyresChanged · 55,265 km€312
Winter tyresReminder · to fit1 Nov

Your tyre questions

What is the legal minimum tread depth in France?

1.6 mm at the bottom of the main grooves. The wear bars, small blocks moulded into the grooves, mark that limit. Below it, the fine is €135 and the car may be held.

At how many millimetres should tyres be changed?

The law says 1.6 mm, but changing them around 3 mm is advised for summer tyres, and around 4 mm for winter or all-season tyres: below that, they brake much worse on wet or snowy roads.

Should all four tyres be changed at once?

No, but both on the same axle, yes: they must be identical. If you only change two, fit the new ones at the rear, as tyre makers advise.

Do tyres have an expiry date?

Not a legal one. Tyre makers advise a yearly inspection from 5 years old, and replacement beyond 10 years even if they look fine. The date of manufacture is in the DOT code.

Can a punctured tyre be repaired?

Often, if the hole is in the tread and the tyre has not been driven flat: a professional repairs it from the inside. On the sidewall, a repair is not possible.

Written by the Hoptro team
Reviewed on 14 October 2026. Spotted an error, have an idea? support@hoptro.com